SYVECS CAN-AM X3 2017-2019 – S7PLUS
SYVECS CAN-AM X3 2017-2019 – S7PLUS
  • Load image into Gallery viewer, SYVECS CAN-AM X3 2017-2019 – S7PLUS
  • Load image into Gallery viewer, SYVECS CAN-AM X3 2017-2019 – S7PLUS

SYVECS CAN-AM X3 2017-2019 – S7PLUS

Regular price
€3.294,00
Sale price
€3.294,00
Regular price
€0,00
Sold out
Unit price
per 

The Syvecs CAN-AM Maverick X3 Plug N Play Kit brings a whole new level of Engine Management Control to the CAN-AM range.

The Syvecs CAN-AM Maverick X3 PnP kit brings a new level of Engine Management Control to the CAN-AM 2017 – 2019 models

By simply plugging in the kit, a whole new level of control is available offering the following features:

• Live Tuning of every aspect of the engine’s calibration.

• Ability to select desired engine map, boost level, traction and launch control levels through 12 Position external switch or via OEM Sport/Eco Button having 2 calibration options.

• Fully adjustable Launch control with Anti-lag strategies and Ramp in Maps.

• Closed loop Lambda Control using NTK Lambda.

• Flex Fuel control.

• Additional Injector support for 6 Stage Injectors.

• Factory DPS control all working and OEM Dash.

• Fully adjustable closed loop boost control with launch level adjustments and trims for turbo speed, air charge, engine coolant temp, exhaust gas temperatures etc.

• Monitor and trimming of exhaust gas temperatures.

• Built in data logging using a market leading analysis software of up to 8 hours, with data rates at up to 1000hz.

• Rolling Antilag / Pit lane limiter strategies. Great for building boost on a roll.

• Anti-theft and valet modes.

• Super fast connection via RJ45 Ethernet port for live tuning anywhere in the world or even remotely if on track and connected to a wireless unit.

• Adjustable traction control strategies based on lateral g, GPS Speed and/or individual wheel speed monitoring.

• 4 programmable and selectable target slip maps. An immediate torque reduction can be applied by the ECU via ignition retard or a fuel cut.

• Configurable Engine Safety Trips on all important parameters such as oil temperature and oil pressure.

• Fuel pump control of both main direct injection pumps and sub pumps, as well as relative fuel pressure monitoring and limiting in the event of fuel pressure dropping on boost.

• 4 different Pedal to Throttle Angle maps with multipliers for different parameters e.g. speed. Again adjustable via steering wheel buttons.

• Configurable individual cylinder closed loop knock control, to suit any cylinder modification with adjustments to frequency, windows for listening and gains for each cylinder. Ability to trigger full cylinder shutdown in severe knock conditions.

• Ability to change Torque ramp in after launch.

• Run up to 7bar map sensors.

• Change injector dead times based on voltage levels for proper control.

• Change injector end angle to ensure injection point is properly calibrated.

• Ability to fit any type of external sensor to monitor and trigger safety trips from anything such as crank case pressure to damper position.

• Ability to use any size DBW throttle body e.g. Chevrolet LS7.

• Wet and Dry – wet and dry nitrous control with ability to drive solenoids directly and control n20 heaters via pressure monitoring.

• Ability to control any external vehicle features based on sensor inputs e.g. Adjustable rear wing linked to G force or exhaust control valves.

• Connect any race series dash or even one of our partners’ Touchscreen CANBUS adjustment /display units.

• View any input live with built in scope up to 1000hz.

• And much, much more!